[nasa$]

coba ini:

* setelah login ketik start networking
* trus startx

* buka terminal ketik ifconfig
* lihat ethernet apa aja yg ke-detect
contoh kaya punya ane :

root@bt:~# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:239 errors:0 dropped:0 overruns:0 frame:0
TX packets:239 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:35601 (35.6 KB) TX bytes:35601 (35.6 KB)

wlan0 Link encap:Ethernet HWaddr 00:21:27:ee:4d:3c
inet addr:192.168.0.72 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::221:27ff:feee:4d3c/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:358690 errors:0 dropped:0 overruns:0 frame:0
TX packets:288677 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:511680186 (511.6 MB) TX bytes:23976215 (23.9 MB)

root@bt:~#


* buka wicd -> preferneces -> General setting
* di wireless interface masukin ethernet ente

* refresh connection
* pilih nama wireless access point trus setting properties
* setting parameter koneksi sesuai dengan wireless access point