Menggunakan modem Air Flash di backtrack
#17
coba ketik di console wvdialconf
nantik muncul seperti ini
Code:
Scanning your serial ports for a modem.

Modem Port Scan<*1>: S0   S1   S2   S3   S4   S5   S6   S7  
Modem Port Scan<*1>: S8   S9   S10  S11  S12  S13  S14  S15  
Modem Port Scan<*1>: S16  S17  S18  S19  S20  S21  S22  S23  
Modem Port Scan<*1>: S24  S25  S26  S27  S28  S29  S30  S31  
ttyUSB0<Info>: Device or resource busy
Modem Port Scan<*1>: USB0
WvModem<*1>: Cannot get information for serial port.
ttyUSB1<*1>: ATQ0 V1 E1 -- OK
ttyUSB1<*1>: ATQ0 V1 E1 Z -- OK
ttyUSB1<*1>: ATQ0 V1 E1 S0=0 -- OK
ttyUSB1<*1>: ATQ0 V1 E1 S0=0 &C1 -- OK
ttyUSB1<*1>: ATQ0 V1 E1 S0=0 &C1 &D2 -- OK
ttyUSB1<*1>: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 -- OK
ttyUSB1<*1>: Modem Identifier: ATI -- Manufacturer: StongRising.CO
ttyUSB1<*1>: Speed 9600: AT -- OK
ttyUSB1<*1>: Max speed is 9600; that should be safe.
ttyUSB1<*1>: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0 -- OK
WvModem<*1>: Cannot get information for serial port.
ttyUSB2<*1>: ATQ0 V1 E1 -- failed with 2400 baud, next try: 9600 baud
ttyUSB2<*1>: ATQ0 V1 E1 -- failed with 9600 baud, next try: 9600 baud
ttyUSB2<*1>: ATQ0 V1 E1 -- and failed too at 115200, giving up.
WvModem<*1>: Cannot get information for serial port.
ttyUSB3<*1>: ATQ0 V1 E1 -- failed with 2400 baud, next try: 9600 baud
ttyUSB3<*1>: ATQ0 V1 E1 -- failed with 9600 baud, next try: 9600 baud
ttyUSB3<*1>: ATQ0 V1 E1 -- and failed too at 115200, giving up.

Found a modem on /dev/ttyUSB1.
Modem configuration written to /etc/wvdial.conf.
ttyUSB1<Info>: Speed 9600; init "ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0"
itu punya ane terdeteksi di ttyUSB1
kalau not found bearti modemnya belum detek
Semangat Belajar Backtarck


Messages In This Thread
RE: Menggunakan modem Air Flash di backtrack - by jufianto - 06-15-2012, 11:00 PM




Users browsing this thread: 1 Guest(s)