Making an Electronic Torch – Schematic, PCB Version and Breadboard Version - Printable Version +- Indonesian Back|Track Team (https://www.indonesianbacktrack.or.id/forum) +-- Forum: General Zone (https://www.indonesianbacktrack.or.id/forum/forum-172.html) +--- Forum: Hardware (https://www.indonesianbacktrack.or.id/forum/forum-155.html) +---- Forum: Robotica (https://www.indonesianbacktrack.or.id/forum/forum-205.html) +---- Thread: Making an Electronic Torch – Schematic, PCB Version and Breadboard Version (/thread-6194.html) |
Making an Electronic Torch – Schematic, PCB Version and Breadboard Version - mywisdom - 02-09-2015 Original Source: https://sw0rdm4n.wordpress.com/2015/02/09/making-an-electronic-torch-schematic-pcb-version-and-breadboard-version/ by : Antonius (@sw0rdm4n) http://www,ringlayer.net Electronic Torch is an unique electronic circuit to learn about how electric flow through each components. Below is the electronic circuit: Part Lists Based on Above Schematic – 2 resistor 330 ohm or 320 ohm. (breadboard version can uses up to 3 resistors) – 3 led – 3 switch – 1 Dioda in4001 How this works on PCB Version ? Below is the electronic circuit logic flow : – If switch is on, the current will flow through: D1 (since it’s a dioda it will prevent reverse current) -> switch -> R1 -> led1 -> led2 -> ground – If s1 is on, the current will flow through: D1 -> S1 -> R1 -> led1 -> led2 -> ground. – if s2 is on, the current will flow through: D1 -> S2 -> R2 -> led 3 -> ground Solder each component based on above schematic Note: – Clean your solder with sponge before soldering – Before soldering drop some soldering tin on top of your solder – Don’t use to much soldering tin And here comes the pcb version of the torch : Breadboard Version We can also making breadboard version, vero board version, and so on. Here’s the breadboard version of this electronic torch with 3 resistor (1 resistor 330 ohm and 2 resistor 320 ohm). To see how this circuit works, you can see this video: RE: Making an Electronic Torch – Schematic, PCB Version and Breadboard Version - Afif BlackHunter - 02-09-2015 ijin share ilmunya bleh bro keren bro RE: Making an Electronic Torch – Schematic, PCB Version and Breadboard Version - dunkenciels - 02-10-2015 Deleted |